I have 4003 series switch with version 6.1(2).My IP phone is not receiving inline power from 4003 sereis switch. I have inline ws-4148-RJ45 blade in 4003.I have 2 power supplies installed. When I give show environment power I get the follwoing statistics. Total inline power :0 wattt, Total inline power drawn from system:0 watt. What is wrong ? DO i need to update the CAT IOS or do i need to do any special configuration.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.