Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP Phone gets rebooted

Dear All,

We have an ip phone 7960 which is connected to 4006 access switches, whenever we chage the port speed to 10/100 full duplex mode on both VoIP and Switch port, the VoIP gets rebooted continously.

Kindly help on the same.

Naresh

4 REPLIES
New Member

Re: IP Phone gets rebooted

yes, that will happen for sure.

connect a pc to a switch port, play with speed and duplex and see what happens to connectivity.

the same rule applies on IP phones too.

there are some documents explains this situation.

Regards

taib

New Member

Re: IP Phone gets rebooted

Hi Taib,

Thanx for your quick reply.

We tried connecting only PC but works fine, the problem only occurs withh VoIP's. Which ever phone's speed/ duplex we changed not allowing to change to auto mode i meand to say that we not able to do anything as the phone gets rebooted again and again.

and in syslog it shows only "duplx mismatch" mssgs when we connect the VoIP.

Regards,

Naresh

New Member

Re: IP Phone gets rebooted

please refer to this URL:

http://www.cisco.com/en/US/tech/tk389/tk214/technologies_tech_note09186a0080094781.shtml

ok. jsut break down the case.

1. remove ip phone from switch. configure switch port to be duplex and speed auto.

2. plug to power 'just power' and select network settings, press #**#, you will see the lock key is open, press 33, 'erase network configuration, press soft key 'yes', then soft key 'save', wait for 5 seconds and unplug the phone immediatly from the power. plug into switch port again.

3. very basic tip. if you are using an external power cube, connect network cable before you connect power.

4. again verify line # 40 in network configuarion (dont forget to unlock the key) switchport is set to auto. dont forget to validate and save in each levels.

things must be fine now.

if nothing works, check your cabling, switch port physical errors or try other phone is port.

regards

taib

New Member

Re: IP Phone gets rebooted

We already changed the duplex/speed of the switch port to auto mode, but the problem with the VoIP is before anything displays on the VoIP screen the phone gets rebooted and this happens continously,we are not able to see any of the settings of VoIP.

Other VoIP works fine on the same switch port which is having duplex/speed in auto mode, problem occurs only when we change the duplex to full and speed to 100 and in this issue we already lost 3 VoIP's

Regards,

Naresh

100
Views
0
Helpful
4
Replies
CreatePlease to create content