Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

IP Phone to IP Phone caller ID?

Hello all,

This is CCM 4.1

When the Display (Internal CAller ID) is set on a DN, and I receive a call from that DN, my IP phone displays "call from Joe Smith". However, when I call Joe Smith's extension, it just says "to 3000". I could have sworn it was supposed to say "to Joe Smith"

Am I just losing my mind, or is this only a CME feature? I don't have another CCM system to test with...

Thanks.

4 REPLIES

Re: IP Phone to IP Phone caller ID?

This feature does work in CCM as well. Make sure Alerting Name is also set to "Joe Smith" in DN configuration. This normally gets set by default when you populate the Display (Internal Caller ID) field.

Hope this helps. If so, please rate the post.

Brandon

New Member

Re: IP Phone to IP Phone caller ID?

Ah, that did the trick! Thanks!

New Member

Re: IP Phone to IP Phone caller ID?

Hmm for some reason it doesn't show up when I try to rate the post...

aj
New Member

Re: IP Phone to IP Phone caller ID?

Hi

Did the solution solve your problem?

I have the same problem. When I dial another Ip Phone it first says "To 3000" but when the call is answered i can see "to Joe Smith"

217
Views
0
Helpful
4
Replies
CreatePlease to create content