I have the attached diagram, and want IP phones located at the branch offices (Grupo 1, 2 y 3) to use the remote CUE located at the HQ (Central) via SIP. I know that CUE is a SIP destination I know that this can be do with H.323, H.450 transfer and H.323 translation to SIP. But I want a full SIP network without H.323 translations.
Can I do that, is there any reference that talks about this environment ?
The proxies will then initiate calls toward thereal H.323 and SIP nodes in the Inside. All source and destination IP addresses are now of hosts within DMZ and Inside. Using PIX will help from avoiding H.323 translations
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4