One of our customer plan to use IP Phones (and softphones) over LRE connection. In most case only one IP phone will be connected to the LRE CPE (575) and a personnal computer will be connected to the phone. In some cases the phone will be integrated in the PC (softphone). It is also consider to connect many phones using a switch (3524-pwr) connect to the CPE... in this case many IP phones will used the same LRE connection.
Is anybody have tried a configuration like this one (LRE CPE-575 with IP Phones) ?
Is there any mechanisms that I could implement to insure QoS for voice call in CPE to SWITCH direction ?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...