Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IP phones and power supply

Have found those power supplies for 6500 series.

950W AC input (Cisco Catalyst 6503 chassis)

1400W AC input (Cisco Catalyst 6503 chassis)

1000W AC input

1300W AC and DC input

2500W AC and DC input

3000W AC input

4000W AC input

I used the Cisco Power calculator on the web and try to find out which power supply we should use. We have 170 IEEE Class 3 phones, Cat6509, and we can only use AC100V power input. The power calculator shows the number of ip phones are exceeding the Cat6509 2500W AC power requirement even running in combined mode. In this case, do we need to buy another switch or what is the amps of 3000W AC? We can't use 4000W AC power as this is only for AC240V.

Please advise,

1 REPLY
Silver

Re: IP phones and power supply

Check the below link for the power supply. You can go for the Catalyst inline power patch panel

http://www.cisco.com/warp/public/cc/so/neso/vvda/iptl/cippp_ds.htm

187
Views
0
Helpful
1
Replies
CreatePlease login to create content