ā11-15-2010 04:26 AM - edited ā03-13-2019 07:13 PM
Dear guys,
My customer has a problem.Once they dial from IP phones it gets about30 seconds to ring(very slow).These phones are connected to the voice gate 2.But the phones which are connected to the voice gateway 1 is working fine without any delay.Whta could be the problem?Can any body guide me where to look?Any hints ..really appriciate.
Thanks
ā11-15-2010 07:56 AM
What is the topology? Elaborate:
* CME or CUCM?
* What PSTN circuit are you using? PRI? T1-CAS? E1R2? SIP ITSP? FXO?
* If this is CUCM:
a) What VoIP protocol are you using? H.323, SIP, or MGCP?
b) What is the formatting of the route pattern which you are hitting? Is there overlap with another pattern that has a longer match?
ā11-20-2010 02:24 AM
Hi ,
When I see the logs I noticed,the foolowing.
Do u think it can happen because of this fan failure??
VG1# sh environment
Power Supply:
Redundant Power System is not present.
Board Temperature:
normal.
Fan status:
Warning - low fan rpm condition detected.
---this is 3725,protocol PRI
thx
ā11-21-2010 05:03 AM
I don't think that's the root of the issue. Are you seeing high CPU?
You need to answer all of my questions in the first post for me to be able to let you know what/where you should be looking at.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: