Could somebody tell me how to get multiple PC's from an inside network and an outside (public network) to log into an MCU gatekeeper and register with a password ex. 6509 through netmeeting, and have video both ways etc... Also A user from behind a nat router, ex. dling home soluion. I look in the MCU and see the private address from this PC connected, but it never connects on the home side. I am assuming it has no route back to a 192.168.0.0 network.
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.