We have a IP/VC 3520 and I was wondering if it can be configured to run through the V.35 module into an external CSU and then into our PBX and out through the local PRI. We were looking for a less costly method then installing and maintaining 4 ISDN lines.
The V.35 modules on the 3520 can be interfaced with an external CSU or IMUX to run off a PBX. Note however that a single V.35 module can handle only one video gateway session at a time regardless of the number of B-channels youmay have available
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...