I like to setup CRA 3.1 in a CM 3.3(3) environment, where the CM is a 7835 and the CRA server will be a 7825. In CRA 3.1 it should be possible to install CRA on a server where no CM is installed. During the installation it looks that everything goes well, till the end of the installation. It comes with the following popup:- Customer Response Applications failed to install
Customer Response Applications Language Pack failed to install
SpanLink TAI failed to install
Does someone seen this problem before and knows what goes wrong??? Other suggestions are welcome to.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.