Re: IPCC Enterprise Dialer configuration for Blended Agent
I currently have a TAC case open to get a definitive answer on this but what I had to do was create a new device pool and only assign one CallManager to it. Then place the phones that will be used for the Blended Agent in that dev pool. During the dialogictest when the phones had two callmanagers assigned it would register back and forth between cm's. Try that and then post the output from your dialogictest.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.