Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IPMA problem after upgrade ccm

After upgrading ccm from 3.3.3 to 4.1.2(sr1), IPMA doesn`t work.

IPMA application starts, RP get registered, IPMA gets the directoy numbers defined in RP, RP goes to unregistered status and IPMA application shuts down.

Can enybody help!

thx

1 REPLY
Hall of Fame Super Red

Re: IPMA problem after upgrade ccm

Hi Darijo,

I'm not sure what kind of errors you are seeing so I have attached a link for troubleshooting IPMA on CCM 4.1.2. Have a look at it, also I did see a BUG that sounds exactly like this problem;

Troubleshooting Cisco IP Manager Assistant - CCM 4.1.2

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00802e21f9.html#wp1012318

CSCuk54338 Bug Details - IPMA CTI RP do not register after upgrade

Hope this helps!

Rob

Please remember to rate helpful posts.....

137
Views
3
Helpful
1
Replies
CreatePlease login to create content