I have an issue that i have two dn for one user for EM if he log on he can use the firs DN wich allow him to make a national call and when he log out he will have another DN wich only allow him to call internally. I allrady make a forward call when the DN not registered to the other DN wich is original but when he used the other DN it shown the un original one how can i make the un original DN shows the original DN in other devices for Ex.
I have DN 5115 as original DN but when the user log out he will use DN 5300 and this DN forwarded to 5115 when it no registred till now everything is ok but when the user try to call internally it show 5300 in the other devices which is not needed how can i present the DN 5115 istead of 5300.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...