We are facing some issues when trying to integrate a IPT solution. I dont have much experience with IPT CCM.
We have a solution that involves a Multilayer Switch with 2 VLANs (VLAN 1 and VLAN 2). All the IPT Solution equipment are on VLAN 2 (this involves the CCM, IOS Gateway and the IP Phones). When I place a call between these IP Phones everything works great.
BUT When I try to place a call from a SoftPhone in VLAN 1, I get one-way audio (The SoftPhone never listen anything).
The IOS Gateway that I mentioned before is making intervlan routing (routing on a stick) between VLANs, so it has two subinterfaces, one in VLAN 1 and the other in VLAN 2. I tried to enter the h323-gateway voip bind srcaddr command, I get that I can not use that command on a subinterface.
Other thing is that when I try to get a PSTN line from the same Softphone on VLAN 1 I never get the dial tone, but I can dial the rest of the digits, and the call gets complete, but again it is only one-way.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.