Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ipv6 analog phone

Hi

wanted to implement the following:

analog_phone--router-----ipv6 backbone-----router---analog_phone

seems that the IOS 12.4(5) doesn't support this command

Router(config-dial-peer)#session target ipv6:2000::1/64

Incorrect format for Session Target

Must be of the form ^((loopback:rtp)|(dns:.*)|(ipv4:[0-9]+\.[0-9]+\.[0-9]+\.

[0-9]+(:[0-9]+)?)|(enum:([1-9]|1[0-5]))|(ras)|(sip-server))$

Or ^((settlement)|(settlement:[0-0]+))$

any solutions?

is DNS a solution!?

thanks in advanced,

Hugo

1 REPLY
Silver

Re: ipv6 analog phone

As of now IPv6 addresses are not supported in the 'session target' command.

http://www.cisco.com/en/US/products/ps6350/products_command_reference_chapter09186a0080457369.html#wp1233986

DNS could be a workaround for implementing this. Make sure your DNS server can work with AAAA records, which is used to store IPv6 addresses.

102
Views
0
Helpful
1
Replies