Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is Analog E & M capable of DID?

Can Analog E&M 2 or 4 wire handle DID? I am not aware of this but if someone has knowledge of this I would appreciate it.

Thanks

Mike

  • Other Collaboration Voice and Video Subjects
5 REPLIES
New Member

Re: Is Analog E & M capable of DID?

Yes, analog E&M supports DID. I believe that there are some limitations on passing ANI over analog E&M so you won't get CLID.

New Member

Re: Is Analog E & M capable of DID?

Do you have some doc you can point me to?

Thanks!

Mike

New Member

Re: Is Analog E & M capable of DID?

As far as I know, the only way you can get callerID info from e&m is through fgd (feature group d) signalling from the telco. Never seen it offered in my area.

New Member

Re: Is Analog E & M capable of DID?

New Member

Re: Is Analog E & M capable of DID?

Caller ID is also supported with FGB on T1 CAS interfaces

292
Views
0
Helpful
5
Replies