I have two sites connected between 805 routers. I have one ATA 186 in each site and want to connect it to a PBX, to allow to make calls between both sites. Is it possible ? Do it need any special configuration ?
it would be possible but you would have to make sure that the pbx had some analog trunk cards that suppoer loop start. you can not hook the ata to a analog station since the ata and a analong station from the pbx are both ring generators and not ring listeners.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...