Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Is it possible to have SRST as a failover of CM 3.1 in the same Lan?

I do want to set up SRST on the Gateway for failover suport of the Call Manager in the same LAN. Is it possible?

Which will be my problems in this configuration?

4 REPLIES
Cisco Employee

Re: Is it possible to have SRST as a failover of CM 3.1 in the s

I don't think there will be a problem with this. It should not matter if it is the same vlan as the ccm or not. The thing it should try to open the default gateway when it cannot connect to ccm and the phone is configure for srst in ccm device config.

Thank you,

-Mckee

New Member

Re: Is it possible to have SRST as a failover of CM 3.1 in the s

When the CM fail the gateway with SRST handle the phone, but what happens when the CM is alive again. Will the phone come back to CM?

Thanks in advance

Cisco Employee

Re: Is it possible to have SRST as a failover of CM 3.1 in the s

When the ccm comes back, the phone will automatically goes back to CCM

New Member

Re: Is it possible to have SRST as a failover of CM 3.1 in the s

How it works?

Thanks in advance

MP

93
Views
0
Helpful
4
Replies