Re: Is it possible to set forward no answer delay timeout on ind
You can set this under the Service Parameters in the CCM Administration page. I think the value is Forward No Answer...and it's value is in seconds. One ring cycle is approximately 4 seconds, so for your example, you would need to change the parameter to 20 seconds, update and reboot the server.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.