Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Is PSTN callerID (enabled, telco end) possible over FXO?

Hi,

Just want to know if the callerID is enabled at the telco end and works on a standard phone will the same work over a fxo port?

port configs

!

voice-port 1/0/0

cptone GB

connection plar 01908601000

IDEAS PLEASE.

ring number 3

5 REPLIES
New Member

Re: Is PSTN callerID (enabled, telco end) possible over FXO?

Hi,

I have configured caller-id with fxo-m2 and it works, provided that the line from the telco has enabled caller-id. Make sure to know the caller-id standard being used in your area because every cptone has different standards. By the way I'm using H.323 with CallManager 3.1, MGCP with CallManager 3.1 does not support caller-id.

Hope this will help.

Arvin

New Member

Re: Is PSTN callerID (enabled, telco end) possible over FXO?

We are using 3.1(4b) with MGCP over PRI on a 3662 router and caller ID is working pretty well. Outbound name and number work fine. Inbound number works fine, but not name - I am told that is a MGCP compatibility issue with certain types of Lucent switch signallings that will likely be fixed in an early patch following CM 3.3.

- Ken

Ken Johnson

Mgr. Network Services

LeTourneau University

http://www.letu.edu

---------------------------------

CIPTUG

Cisco IP Telephony Users Group

http://www.ciptug.org

New Member

Re: Is PSTN callerID (enabled, telco end) possible over FXO?

Caller ID also works with fxo-m1 cards.

I believe the command is something like:

voice-port 1/0/0

caller-id enable

New Member

Re: Is PSTN callerID (enabled, telco end) possible over FXO?

I currently do not have his command available in this image: c2600-is3x-mz.122-13.T.bin. This FXO card VIC-2FXO-M2.

What IOS image are you running?

Thanks,

George.

Re: Is PSTN callerID (enabled, telco end) possible over FXO?

you need IP Plus ios, and you can run debug vpm signaling, and look to ensure the telco is sending caller ID and Name info.

108
Views
0
Helpful
5
Replies
CreatePlease login to create content