I have an AS5350 and am using 827-4V endpoints. The endpoints have their 4 FXS ports connected to analogue CO cards in small PBX´s. Port 1 has the company main number , ports 2 , 3 and 4 have other numbers.
The problem is that if a call to the main number is answered , another call to the main number is not possible - dialler gets busy tone . Is there ANY way to enable further calls to thye main number appear at (the) other ports ? Anything I can do with the dial peers ?
I guess what is needed is some kind of call processing --- call fwd on busy to port 2 etc , or a ring group of ports 1,2,3 etc.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...