Looking for a good document with ISDN BRI sample configs specifically dealing with VG200 and NM-HDV-2IT1-48 module. I've found lots of documentation for PRI, and know I've seen the same for BRI. I just can't seem to find it today. The Quick Start that accompanies the T1 module should have this info, but I can't find that online either.
Thank you, the second document is very thorough. Stupid me, I didn't even realize that I had the incorrect hardware. I've done PRI before, but not BRI. Noticed the limitations regarding number of calls and I guess that explains the difference in cost between BRI/PRI line and hardware. Working with my client to migrate from analog to digital and seems to me that the better investment is PRI since call volume will be limited to 4 calls on BRI. Again, thank you.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.