Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

ISDN BRI NT and VoIP

I have a problem with VoIP over ISDN BRI connection in the following configuration:

phoneA--PBXa--routerA======routerB--PBXb-phoneB

Connection between routers and PBXs is made by ISDN BRI using VIC-2BRI-NT/TE in routers.

Ports BRI on routers are configured as NT (network side).

Routers are connected together with leased line (2Mb/s).

When phoneA initiates voice call to phoneB following is happened :

1. routerA transmits VoIP packets to routerB,

2. routerB transmits one SETUP frame (ITU Q.931) to PBXb; after 4 seconds next SETUP

frame

3. PBXb is not responding

4. after few seconds routerA transmits DISCONNECT to PBXa with cause=0x80A2 No circuit/channel available

Transmitted numbers are correct. Layer1 and 2 - correct.

If anybody is interested - I have logs from debug isdn q931 and debug voice ccapi inout.

Thank you for any suggestions.

Przemo

4 REPLIES
Cisco Employee

Re: ISDN BRI NT and VoIP

The log of debug isdn q931 on routerB would be helpful here. But I am thinking that we need to figure out why when we send a Q.931 SETUP message to the PBXb that it does not respond. Most likely the problem is there.

Community Member

Re: ISDN BRI NT and VoIP

Hi

We would like to know we can enable load balancing & Dial backup between two unequal cost links in 1750 router or not. We are using ISDN BRI and Leased line and a choice of OSPF,IGRP & EIGRP.

Community Member

Re: ISDN BRI NT and VoIP

could you post the configuration of your router?

Community Member

Re: ISDN BRI NT and VoIP

Send me the trace and config files and I can take a look at them.

keith_yam@hotmail.com

Yuenme

151
Views
0
Helpful
4
Replies
CreatePlease to create content