03-21-2006 07:50 AM - edited 03-15-2019 04:12 AM
Hi,
i've a router 2801 with the card VIC2-2BRI, i've this problem:
when i plug-in in ISDN cable on the BRI interface the interface BRI doesn't change the state to up, it seems that the cable is not connected.
I need to reboot my router with the ISDN cable plugged in, and when the router starts, the BRI interface is active.
anybody know how to solve this problem?
This is my ISDN bri configuration:
------------------------------------
network-clock-participate wic 3
interface BRI0/3/0
no ip address
isdn switch-type basic-net3
isdn point-to-point-setup
isdn incoming-voice voice
isdn bind-l3 ccm-manager service mgcp
isdn sending-complete
voice-port 0/3/0
output attenuation 10
echo-cancel coverage 32
no vad
compand-type a-law
cptone IT
-----------------------------------
it use MGCP protocol to comunicate with my callmanager.
thanks in advance,
Claudio.
03-27-2006 07:31 AM
06-28-2006 05:30 PM
You are hitting the same bug I am, I am getting Cisco to raise a defect.
Andy
07-02-2006 02:28 PM
Could you provide Bug description or Bug ID #?
TIA!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: