Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISDN doesn't change to state up - only after reboot

Hi,

i've a router 2801 with the card VIC2-2BRI, i've this problem:

when i plug-in in ISDN cable on the BRI interface the interface BRI doesn't change the state to up, it seems that the cable is not connected.

I need to reboot my router with the ISDN cable plugged in, and when the router starts, the BRI interface is active.

anybody know how to solve this problem?

This is my ISDN bri configuration:

------------------------------------

network-clock-participate wic 3

interface BRI0/3/0

no ip address

isdn switch-type basic-net3

isdn point-to-point-setup

isdn incoming-voice voice

isdn bind-l3 ccm-manager service mgcp

isdn sending-complete

voice-port 0/3/0

output attenuation 10

echo-cancel coverage 32

no vad

compand-type a-law

cptone IT

-----------------------------------

it use MGCP protocol to comunicate with my callmanager.

thanks in advance,

Claudio.

3 REPLIES
Bronze
New Member

Re: ISDN doesn't change to state up - only after reboot

You are hitting the same bug I am, I am getting Cisco to raise a defect.

Andy

New Member

Re: ISDN doesn't change to state up - only after reboot

Could you provide Bug description or Bug ID #?

TIA!

107
Views
0
Helpful
3
Replies