01-21-2009 04:37 AM - edited 03-13-2019 06:00 PM
I am configuring an ISDN E1 PRI Connection
(1/2 Port Channelized T1/E1 PRI Network Module)
When I configure the E1 controller example add the framing and pri-group timelots in the E1 controller. The voice port {voice-port 1/0:15 in my case}is not created for me to point my pots dial-peers.when I do a show voice port summary its not shown but when i do a show ip interface brief serial 1/0:15 is up. The conclusion is its not creating the voice port after I have entered the pri-group timeslots command. Please help. Thanks
Solved! Go to Solution.
01-23-2009 01:36 AM
Your are right!Thank you so much Nick for your help. I truly am a big fan. Could you recommend a replacement part number. I assume I should go for NM-HDV2-2T1/E1 any suggestions.
01-23-2009 04:40 AM
I wouldn't go with the NM-HDV, they use an older model DSP.
I would stick with straight PVMD2-X and VWIC-T1 cards.
hth,
nick
01-23-2009 05:50 AM
Nick do you suggest VWIC-2MFT-E1
01-23-2009 06:04 AM
Yes, it's a standard card with full feature support.
01-23-2009 06:53 AM
Thank you once again for your support Nick.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: