I have 2611XM with NM-HDV2-2E1 and IOS 12.3(14)T6.
I have configured everything as usally but this time Layer2 didn't came up. I have experimented with other E1 connection and problem is the same. Router is user side and in debug isdn q921 i only saw user TX sapi=0, tei=0.
In show controllers i don't have alarms
and i saw that clock is recovered from that E1.
In show network-clocks i saw E1 clock good but backplane not available.
I have a impedance converter from 75 Ohms to 120 ohms.I have already changed it.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.