Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN Messages

Hi Expert's

someone know how to turn off the next ISDN messages from terminal monitor:

VoIP-GW-02# terminal monitor

VoIP-GW-02#

110000: Dec 18 20:24:52.255: %ISDN-6-CONNECT: Interface Serial0/1/1:1 is now connected to 22904270 N/A

110001: Dec 18 20:24:52.879: %ISDN-6-CONNECT: Interface Serial0/1/1:30 is now connected to 22730911 N/A

110002: Dec 18 20:24:55.219: %ISDN-6-DISCONNECT: Interface Serial0/1/1:30 disconnected from 22730911 , call lasted 2 seconds

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: ISDN Messages

Hello,

Configure "no logging event link-status" under the interface.

GW01#config t

GW01(config)#interface serial 0/1/1:23

GW01(config-if)#no logging event link-status

hth,

Jesse

3 REPLIES

Re: ISDN Messages

I believe this is a aaa command.

I would do a sh run | i aaa

I believe it is aaa gw-accounting or something similar.

New Member

Re: ISDN Messages

Hi nicmatth

This is the result of the sh run| i aaa

VoIP-GW-02#sh run | i aaa

aaa new-model

aaa authentication login LocalDB local

aaa authentication login ACS group radius local

aaa session-id common

Do you see something?

Thanks

Cisco Employee

Re: ISDN Messages

Hello,

Configure "no logging event link-status" under the interface.

GW01#config t

GW01(config)#interface serial 0/1/1:23

GW01(config-if)#no logging event link-status

hth,

Jesse

324
Views
2
Helpful
3
Replies
CreatePlease to create content