Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ISDN Numbering plan being sent as unknown

Cisco AS5850 switch type 5ESS,

Voip->PSTN calls go out with the plans set as unknown, and I would like it to be national, I tried doing this in the translation rule but it seems to have no effect.

Any ideas are appreciated.

2 REPLIES
Bronze

Re: ISDN Numbering plan being sent as unknown

To convert the Numbering Type and Numbering Plan we have to use a voice translational rule.This feature is however available in 12.2(11)T.So please check which IOS version are you using.

please refer this link

http://www.cisco.com/en/US/products/sw/iosswrel/ps1835/products_configuration_guide_chapter09186a0080080aec.html#1279112

New Member

Re: ISDN Numbering plan being sent as unknown

Thanks but that wasn't changing it I found the command needed via searching through tac

it was

isdn map address .......... plan isdn type national

isdn map address 1.......... plan isdn type national

under the serial config for the span

thanks

361
Views
0
Helpful
2
Replies
CreatePlease login to create content