I tried to set up the AS5300 w/ termination as an ISDN PRI but after tried to make a voip call it give the Disconnection cause no. 64 "invalid ie content". I tried to search the web but to no avail. Any ideas on this.
Can you please post all of the output you got from debug isdn q931 when the call fails. Also please post the output of the following commands: show version, show vfc 1 ver vcw, show vfc 2 ver vcw, show run.
The remote equipment receives a message that includes invalid information in the information element.
This cause indicates that the equipment sending this has received an information element which it has implemented; however, one or more of the fields in the information element are coded in a way that has not been implemented by the equipment sending this cause.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...