Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

ISDN PRI without DID

I am trying to setup a PRI interface in Beijing they call the service 30b+1d it has only one number, ( DID is a different service) the follwoing is what I get from a q931 debug

Oct 28 15:42:33.913 AU-wint: ISDN Se0/2:15 Q931: RX <- SETUP pd = 8 callref = 0

x002D

Sending Complete

Bearer Capability i = 0x8090A3

Standard = CCITT

Transer Capability = Speech

Transfer Mode = Circuit

Transfer Rate = 64 kbit/s

Channel ID i = 0xA9838E

Exclusive, Channel 14

Calling Party Number i = 0x0081, '13801286605'

Plan:Unknown, Type:Unknown

Oct 28 15:42:33.917 AU-wint: ISDN Se0/2:15 Q931: TX -> CALL_PROC pd = 8 callref

= 0x802D

Channel ID i = 0xA9838E

Exclusive, Channel 14

Oct 28 15:42:33.921 AU-wint: ISDN Se0/2:15 Q931: TX -> DISCONNECT pd = 8 callre

f = 0x802D

Cause i = 0x8081 - Unallocated/unassigned number

Oct 28 15:42:34.009 AU-wint: ISDN Se0/2:15 Q931: RX <- RELEASE pd = 8 callref =

0x002D

Oct 28 15:42:34.009 AU-wint: ISDN Se0/2:15 Q931: TX -> RELEASE_COMP pd = 8 call

ref = 0x802D

had the normal dial-peer config, but didn't work

As you don't see any called number in the signalling I tried putting a "Connection PLAR" command on the voice port still no joy

anybody got any ideas

1 REPLY
Bronze

Re: ISDN PRI without DID

try debug voip ccapi inout. it might have more info that possibly can give you some clues.

125
Views
0
Helpful
1
Replies
CreatePlease login to create content