Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ISDN support on ICS 7750

Does MRP on ICS7750 supports ISDN-PRI connection to integrate with legacy PBX for voice with IP telephony setup ?

We are using MRP on ICS7750 with VWIC-1MFT-E1 with sufficient DSP resources.

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: ISDN support on ICS 7750

This should not be a problem - set the clock source on the controller and the correct isdn protocol-emulate on the serial interface.

Please note this is supported for Q.931 switch types only. Q.Sig is not yet supported (and won't be until at least CallManager 3.3 with MGCP).

Regards,

Justin

1 REPLY
New Member

Re: ISDN support on ICS 7750

This should not be a problem - set the clock source on the controller and the correct isdn protocol-emulate on the serial interface.

Please note this is supported for Q.931 switch types only. Q.Sig is not yet supported (and won't be until at least CallManager 3.3 with MGCP).

Regards,

Justin

96
Views
0
Helpful
1
Replies
CreatePlease to create content