Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ISR2951 running MGCP and Video calls

Hi

Is it possible to run an ISR2951 router in MGCP mode and still do Video calling over the PRI connected to it?  I've found these commands but cannot seem to find a MGCP equivalent of it.

Router(config)# interface Serial4/1:15

Router(config-if)# isdn integrate calltype all

Not sure if I'm understanding this correctly but my understanding is that this enables me to do video calls over the ISDN PRI?  And if so do I just configure this straight on the Serial like above or is there anywhere on the MGCP configuration from CallManager that I need to specify this?

I got this information from here:

http://www.cisco.com/en/US/docs/ios/12_4t/12_4t11/h320gw.html#wp1047659

Any input on this would be appreciated.

Thanks.

312
Views
0
Helpful
0
Replies