Re: It is possible to route a VoIP call trough ethernet port, on
If connected to the PBX via FXO, then you can only make outbound calls towards the PBX as fxo would not generate a dialtone or colect digit from the PBX. Communication in this case would be in one direction i.e.from the
c3600--to--mc3800--to--PBX--to --(phone or PSTN)
1. If you have FXS phone on the mc3810 then yes you can orginate calls on the mc3810 towards the c3660.
2. If you have only FXO on the MC3810 then you can trunk this FXO ports to the remote FXS port and calls coming from PBX through the FXO port can be trunked over IP to the equivalent remote FXS port.
3. If the remote FXS port on 3600 is off-hook, dialtone is sourced from the PBX since its been trunked to the FXO port. The IP cloud thus appear as a long piece of wire connectiing the remote FXS to the PBX.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...