Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ITS 2.1 on a 1760-v

Does any have any experiance on ITS? I've got dial-tone to the phone but I can't seem to place a call. Any example configs would be great.

Thanks in advance

2 REPLIES

Re: ITS 2.1 on a 1760-v

Yes, I have set it up and tested several configuration, do you have dialpeers for pots configured ? This sample below would work, you need to set your pots port of course.

!

dial-peer voice 2 pots

destination-pattern .T

progress_ind setup enable 3

port 2/0/0

!

New Member

Re: ITS 2.1 on a 1760-v

I have those lines configed already except the progress... line. Depending on what number I hit first it lets dial a certain number of digits then busy's out. If I call the number from a regular phone it rings then goes to dialtone as soon as the light come on the FXO port. Any more ideas?

Thanks again

Mike

87
Views
0
Helpful
2
Replies
CreatePlease login to create content