Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ITS and Callmanager

Is there anyway to get the ITS platform on a router to interact with Callmanger on a Server? I want ITS and Callmanager to talk to each other over a WAN through a VPN.

  • Other Collaboration Voice and Video Subjects
1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: ITS and Callmanager

Easy. Create a VOIP dial peer on the ITS router than points to the CM's IP address. Use a destination pattern on the VOIP dial-peer that covers the extension range on the CM.

Create a H323 gateway under the CM that is the ITS router's IP address. On the CM create a route pattern for the ITS extension range and point this to the H323 gateway you have just configured.

Careful planning of dial plans and site number ranges on the CM and the ITS router will prevent messy configs on both devices.

1 REPLY
Silver

Re: ITS and Callmanager

Easy. Create a VOIP dial peer on the ITS router than points to the CM's IP address. Use a destination pattern on the VOIP dial-peer that covers the extension range on the CM.

Create a H323 gateway under the CM that is the ITS router's IP address. On the CM create a route pattern for the ITS extension range and point this to the H323 gateway you have just configured.

Careful planning of dial plans and site number ranges on the CM and the ITS router will prevent messy configs on both devices.

79
Views
0
Helpful
1
Replies
This widget could not be displayed.