The phone registering to it must BE on the subnet directed connected to the router FE interface or there can be a L3 switch (for example) between the router and the phone? Another (similar) question is if I can use a loopback ip address like registering ip address for the skinny protocol or not.
In a lab environment, I have successfully set ip an IP phone on a completely different subnet, separated by a non-ITS router, and it worked. as long as the DHCP scope for the phones hands off the option 150 to the phone, and you have a dial peer set up so that you can call the phone, it should work. I am about to do more of the same in a live environment, so I'll let you know how it goes!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...