Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ITS phone load for 12 SP+ phone

in ITS version 2.1.0.3 I see the option to load 12+ SP image. Where can I get his image, or what is the image's name? Or does this not actually work yet?....

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: ITS phone load for 12 SP+ phone

It actually works, I am sitting in front of two 12 SP+ and one 30VIP that work just fine. The image is the same that is on the callmanager that you are running, I can email you if you would like a copy if you need one. The only trick I ran into is that I had to plug the phones into my callmanager first and have them register so they could download the image file. Once they do that you can plug them into the ITS and the run. You will have to hard code the TFTP IP on the legacy phones. Again the 12 SP+ and 30VIP may work but they are unsupported by TAC.

1 REPLY
New Member

Re: ITS phone load for 12 SP+ phone

It actually works, I am sitting in front of two 12 SP+ and one 30VIP that work just fine. The image is the same that is on the callmanager that you are running, I can email you if you would like a copy if you need one. The only trick I ran into is that I had to plug the phones into my callmanager first and have them register so they could download the image file. Once they do that you can plug them into the ITS and the run. You will have to hard code the TFTP IP on the legacy phones. Again the 12 SP+ and 30VIP may work but they are unsupported by TAC.

110
Views
0
Helpful
1
Replies