Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

IVR Scripting help

Dear All,

I have configured the IP IVR 4.5 with default Script (aa.aef) & working fine. But I want to edit or make a new script as following requirement:

In default, it says that, press 1 for desired extension, 2 for name & 0 for operator.

How can I make it 'If you know your desired extension please dial now or press 0 for the operator assistance.? I need not 1 for extensio & 2 for name & also want to remove # after dialing extension?

Could anyone help me how to make the script like these?

1 REPLY

Re: IVR Scripting help

In simplicity its tough to get around that. There is a way I had hard time.

you can use 0 for operator any time. need # to confirm your input or you can have time out and only take what they input intime and you may get rid of #.

Good luck.

Baseer.

98
Views
0
Helpful
1
Replies