I'm trying to do some initial development of a MIDlet on CUCM 7.0(2a). On the 2 MIDlets I've tried the phone just errors out saying to contact an administrator. I dumped the logs from the phone and see this:
at cip.midp.midletsuite.InstallerModule.a(Unknown Source)
at cip.midp.midletsuite.y.a(Unknown Source)
at cip.midp.midletsuite.y.sinkMessage(Unknown Source)
at cip.sys.n.sinkMessage(Unknown Source)
at cip.sys.aa.a(Unknown Source)
at cip.sys.aa.e(Unknown Source)
at cip.sys.l.run(Unknown Source)
at java.lang.Thread.startup(Unknown Source)
NOT 09:01:18.307772 JVM: Startup Module Loader|cip.midp.midletsuite.InstallerModule:? - Midlet Install Canceled/Error...AnalogWatch
NOT 09:01:18.729701 JVM: Startup Module Loader - Deletion of file Successful/usr/cache/JAD-610373408
It looks as though the phone is looking for the JAD to have a signature. All the MIDlets I have found so far are un-signed. What's the actual requirement for the MIDlet to operate on the phone (load SCCP45.8-4-3S)?
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...