it depends on where your application server sits.. if it's in the voice zone you shouldn't need any changes, but if not, you definitely need to open ports. The ports needed are mentioned in the JTAPI developer guide (it's a single one.. and another one if you use secure JTAPI). Of course, if you want to do media (cti ports, cti routepoints) then you'll need a whole bunch of ports (the JTAPI port plus whatever ports the phones use.. I don't have the link handy but it's part of the callmanager documentation.. a single PDF that lists all ports the callmanager ever uses, including the JTAPI port).
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...