Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Jtech Pager System and FXO

Hello and thanks in advance.

I am attempting to connect a Jtech Pager system to a FXO port. This is not an over head paging system just a pager system that uses one analog line. When I attempt to activate the pager system using the created partition I receive a busy signal.

Will I need a TAMB type device when connecting a pager system? I did not know if this type of device is necessary when using a pager system as it is necessary when using an overhead paging system.

1 REPLY
Silver

Re: Jtech Pager System and FXO

The cables has ot be corss stacked while connecting two switches.

With fallback bridging, the switch bridges together two or more VLANs or routed ports, essentially connecting multiple VLANs within one bridge domain. Fallback bridging forwards traffic that the switch does not route and forwards traffic belonging to a nonroutable protocol such as DECnet.

142
Views
0
Helpful
1
Replies