Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Limited textlength 7920 when displaying Caller-ID

Hi all!

Does anybody knows a solution to the following problem:

My 7920 shows only the first part of a caller id, the last four digits are not displayed, silly because these are most important digits. I run a CCM 3.2.2c, otherwise the 7920 works perfect.

Thanks for any advises!

Andy

3 REPLIES
Silver

Re: Limited textlength 7920 when displaying Caller-ID

This bug causes this problem - CSCdz74344

New Member

Re: Limited textlength 7920 when displaying Caller-ID

Hi!

Thanks for your reply. The bug describes the 7935, but I believe it's the same problem. Unfortunately no workaround exists!

Andy

New Member

Re: Limited textlength 7920 when displaying Caller-ID

I have (3) 7920 phones and all display the caller-id ok. A partial number is displayed in the top left portion of the screen but I can see the full number displayed (albeit in a smaller font) at the bottom of the screen above the "menu" softkey.

I'm running Call Manager 3.3.3(SR1). I believe the 3.3.3(SR1) update added new firmware for the 7920.

Charlie

156
Views
0
Helpful
3
Replies