Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Line occupying algorythm

Hi,

Have the IP Phone 7941 working with CUCM 6.x.

Both of two buttons configured with specific DN (line #1 - 101, line #2 - 102).

When I want to make an outbound on/off-net call from this phone I do one of the following:

1) Dial the number at first, then press 'Dial' softkey, the call proceeds.

2) Press 'New Call' softkey, then dial the number, the call proceeds.

In both cases line #1 is occupied by default for making a call.

Is there any method to change this default occupying behaviour in preference to line #2 ?

I mean somehow to reconfigure CUCM to allow both (1) and (2) tries to occupy not #1, but #2 line ?

Of course I can re-bind line-2-dn associations (line #1 - 102, line #2 - 101), but this is not very appropriate to me.

Thank you.

2 REPLIES

Re: Line occupying algorythm

To the best of my knowledge line 1 is always the primary line and is automatically selected for outbound calls when using the Dial or New Call softkeys.

I do not believe that it is possible to alter this behaviour.

Re: Line occupying algorythm

Best, I think, to approach this from a user training prospective. In method 1, for instance, if the user press the line 2 button, rather than Dial, it will function as you are suggesting.

121
Views
3
Helpful
2
Replies
CreatePlease to create content