Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Linksys CME

Hi, How I can integrate the Linksys telephone, (model SPA922), to Cisco Call Manager Express, version 4.2. ?

5 REPLIES
Hall of Fame Super Gold

Re: Linksys CME

configure voice register dn and pool with the mac address and codec g711u. Configure voice register global. Configure the linksys accordingly. That's all what is required.

New Member

Re: Linksys CME

but, the firmware of linksys phone?? is necessary ?? or not ??

Hall of Fame Super Gold

Re: Linksys CME

Hi,

any firmware on the linksys should be OK. Just enter configuration on the phone via web interface, assign the number and the IP address of the CME for registrar and proxy.

Hope this helps, please rate post if it does!

New Member

Re: Linksys CME

Can you guys post an example configuration of this type of integration?

I have an issue with the same scenario, CME 4.2 and Linksys Phone SPA922. I can make PSTN calls, but I cannot make internal calls between SPA922 phones.

Hall of Fame Super Gold

Re: Linksys CME

Likely the phones are not registered. Do "show sip-ua status registrar" to confirm.

To make phone register, assign user ID same as number, and password.

272
Views
0
Helpful
5
Replies