Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Locale Installation Order with Pub/Sub

Hi,

I'm installing CM cluster 4.2 (1 pub and a few subs).

Wish to apply user/network locale for the cluster.

Documentation recommends

1. Install Pub

2. Install Subs

3. During non Business Hours

3.1 Install locale executable on pub at first.

3.2 Install the same executable on the subs.

3.3 Reload all the servers in the cluster.

4. Apply installed locale value where applicable (e.g. phones)

My question: is the following possible ?

1. Install Pub

2. During non Business Hours install locale executable on the pub and reload the server (cluster contains only pub)

3. Apply installed locale value where applicable (e.g. phones)

4. A few days later install subscribers in the cluster (1 or more)

5. Then run locale installer on the subscriber servers the same way as for pub, reload then.

A little silly question IMHO, but I am in doubt.

1 REPLY
Hall of Fame Super Red

Re: Locale Installation Order with Pub/Sub

Hi Tobivan,

This is actually an excellent question (not silly at all :)

This method shouldn't cause you any unforeseen problems. This is the same way it would happen if you were adding new Subs to an existing cluster somewhere down the road.

Have a great day!

Rob

128
Views
4
Helpful
1
Replies
CreatePlease login to create content