I have centralized Call Processing with remote locations. I have remote regions to use g.729. The remote location has been setup to allow for 1 g.78 call. We have the location setup to for 24KBS. When I place a call from HQ to the remote region I get a fast busy (Not Enough Bandwidth). If a change the region to g.711 and the location to 80KBS, everything works fine. When I set the region back to g.729 and the location to 24KBS, I get (not enought bandwidth)
Also.... If I up the location to 80KBS and leave the codec on the region to g.729 and make a call and press the Information button, it indicates that the call is indeed g.729, however this only works when I have the location set to 80KBS.
AND Yes I have reset everthing assoicated to it multiple times.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...