I need to change the default code for the lock / unlock feature so endusers cannot play with phones. Can I do that? and while I am asking, can the default reset code used on the ip phone be changed to something else?
Thanks for the reply, I have done that. The only problem is the screen contrast and ringer is on that menu also. I was thinking about changing the menu so that it does not show the last three choices if I cannot change the codes.
At the phone configuration menu (Call manager 3.3) there is a parameter named "Setting access", the default value is "Enabled", if you change it to "Disabled" you can lock the setting key at the phone.
You will find it under "device", then "phone", then select a phone and on the phone configuration page at the bottom is where you will find the "settings access" option where you can enable or disable access to the "settings" key.
Hope this helps you, locking people from this also locks them out of adjusting their own ring volume.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4