That is correct my friend :) In most cases people only want this type of Call Blocking for after hours, but in your case you would want to include your working hours in the "after Hours" as well.
after-hours day day start-time stop-time
Router(config-telephony)# after-hours day sun 0:00 23:59
Defines a recurring period based on day of the week during which outgoing calls that match defined block patterns are blocked on IP phones
â¢Enter beginning and ending times for call blocking, in an HH:MM format using a 24-hour clock. The stop- time must be greater than the start-time. The value 24:00 is not valid. If you enter 00:00 as a stop time, it is changed to 23:59. If you enter 00:00 for both start time and stop time, calls are blocked for the entire 24-hour period on the specified day.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...