I wonder if anyone has run into this issue. I have a PRI that is up and working fine, except for the long distance. The long distance provider should be providing a tone to allow the user to enter a pin number or access code to complete the call, but is not, and the call does not go through. When the Long distance provider removes the need for account codes the call goes right through. The Long distance provider says I am not providing the right information (I want to say pick code, but I could be wrong) where can I change that. Or is it something I can change.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.